Dating smith and wesson frame revolvers sights

Smith & Wesson Model 19 - Wikipedia

dating smith and wesson frame revolvers sights

The Smith & Wesson Model 10, previously known as the Smith & Wesson Hand Ejector Model of , the Smith & Wesson Military & Police or the Smith & Wesson Victory Model, is a revolver of worldwide popularity. In production since , the Model 10 is a six-shot, Special, double-action revolver with fixed sights. S&W M&P military revolvers produced from to had. I began collecting and shooting Smith & Wesson revolvers some 45 years ago, The first Chiefs Specials had fixed sights, but beginning in a . most powerful handgun cartridge to date, the Smith & Wesson Mag. Smith & Wesson Model 10 Military and Police Special Revolver review. The S&W Hand Ejector, fixed sight service revolver has, in one form or another, a "V" prefix added to their serial numbers and were known as "Victory" models.

Military and police service, home protection MSRP: The firing pin is pinned into the hammer using a roll pin. There is rebounding hammer with an internal hammer block that positively prevents the firing pin from hitting the primer of a chambered cartridge until the trigger is pulled back, thus rendering the gun safe to carry with the cylinder fully loaded.

Slicking Up The Smith & Wesson Revolver - Part 2

The main hammer spring is a leaf spring inside the grip frame, secured by a screw in the lower front of the grip frame. The trigger pull of the test gun measured a clean four pounds, per my RCBS pull scale. It is probably on the order of 12 to 14 pounds, so heavy that when dry firing I could not keep the sights correctly aligned, no matter how slowly and carefully I tried to pull the trigger. This revolver's DA trigger function is adequate for use at contact range and not much else. If you want to hit what you are shooting at, cock the hammer manually for a SA trigger pull.

However, this test gun has a tight and uniform cylinder gap, tight cylinder crane to frame fit and a uniformly machined cylinder star. The frame is straight and the barrel is correctly aligned in the frame. The side plate fits the frame perfectly, with a nearly invisible line where the two meet. The hand ejector rod is straight, the action is tight and there is very little cylinder play.

dating smith and wesson frame revolvers sights

The locking bolt does not drag between the cylinder locking notches and the cylinder indexes correctly during rapid DA fire. The grip panels correctly match the shape of the frame and are a tight fit. It is one of the good ones!

Smith & Wesson Model 10

For the shooting part of this review I had. Groups were five shots at 25 yards at slow fire pistol bulls eye targets, fired from a sturdy shooting bench using a Pistol Perch rest. We did our test shooting at the Izaak Walton outdoor shooting range south of Eugene Oregon. Overcast skies with a high temperature in the upper 50's F during our day at the range with the Model 10 were typical of Western Oregon weather in mid-March.

dating smith and wesson frame revolvers sights

The maximum wind velocity was MPH. At least it did not rain.

Smith & Wesson Model 10 - Wikipedia

Shooting results Remington gr. I detest plain lead bullets and almost never shoot such ammo in my revolvers, so I don't keep it on hand. Unfortunately, none was available for sale locally, due to the Obama ammo shortage. The sights, although fixed, present a decent, Patridge type sight picture in daylight conditions. Most Victory Models sent to Britain were fitted with 4-inch or 5-inch barrels, although a few early versions had 6-inch barrels.

The Victory Model was a standard-issue sidearm for United States Navy and Marine Corps aircrews, and was also used by security guards at factories and defense installations throughout the United States during the war. Until the introduction of the Beretta M9 9mm pistol inU. Army helicopter crew members and female military police officers were equipped with.

How to Identify/Date a S&W | thedom.info Forums

Criminal Investigation Division agents were issued. Lee Harvey Oswald was carrying a re-chambered Victory Model when he was apprehended on November 22, Other distinguishing features of the Victory Model revolver are the lanyard loop at the bottom of the grip frame, and the use of smooth rather than checkered walnut grip panels.

However some early models did use a checkered grip, most notably the pre manufacture.

dating smith and wesson frame revolvers sights

Along with cosmetic changes and replacement of the frame fitting grip with the Magna stocks, the spring-loaded hammer block safety gave way to a cam-actuated hammer block that rode in a channel in the side plate Smith The model has also been offered throughout the years with both the round butt and square butt, i.